|
Posted by Paul Ekins on March 1, 2006, 2:24 pm
If you were Registered and logged in, you could reply and use other advanced thread options
Not sure without looking at it but I would guess the 7 wires are as follows;
+ hold off
- hold off
bell trigger
+ strobe
- strobe
tamper
tamper
you wont need one of the strobe wires (dependant on trigger) and one of the
tamper if you if you link the other tamper to - hold off.
Good Luck.
--
Paul Ekins
paul@lincsecure.co.uk
www.lincsecure.co.uk
> Hi All,
> I have an optima fx6 alarm panel .The sab has gone down.
> I want to add a texecom odyssey 1e to this panel. Have 7 wires going into
> the old sab but the texecom only uses 5. Customer does not have
> instructions, and texecom manual does not have the optima connections.
>
> Can any one help? please.
>
>
> Thanks
> Mick
>
| 
XML site map