|
Posted by Matthew Brough on March 16, 2008, 2:41 pm
If you were Registered and logged in, you could reply and use other advanced thread options
ADT software for the Galaxy 8+ & 16+ in the UK. In all honesty the 8+ was
just a 16+ board with the ability to add a rio removed especially for ADTs
smaller installs.
They keypads with the coloured buttons had a separate part number to the
normal MK7 keypad, but the only difference is the colouring of the buttons.
The PCB is exactly the same so if you had a normal MK7 keypad on a 16+ with
ADT software, if you pressed *2,5 or 8 it would have the desired effect.
>I have an ADT Galaxy keypad that I am going to fit on a system install for
>a friend. Its the same one as in this picture on www.ebay.co.uk Item
>number 330218907773
>
> Its the one that you can press * and 2, * and 5, * and 8 to summon
> assistance from the Police Fire etc. I have tried hooking it up to my
> system, and can't for the life of me figure out how to configure this
> function. I'm assuming it triggers an output, and you could use the links
> section to signal any other indicators. Anyone got any advice for getting
> these going?
>
> Regards
>
> SantaUK
>
| 
XML site map