|
Posted by bagins on February 15, 2006, 5:30 am
If you were Registered and logged in, you could reply and use other advanced thread options
Check your privileges on the remote system. You must have admin privileges.
Regards
>I work at a school and I am trying to give the lab teacher the ability to
> turn internet access on or off at any time. For 2K using IPSECPOL, it
> works
> fine. For XP using IPSECCMD, I get "Failed to add policy., error 0x5". I
> can run the same command locally and it works.
>
> This command:
> ipseccmd \vmware-xp -f [0:80:TCP=*:80:TCP]
> gives the error message. Using the very same filter statement locally, it
> works immediately. Something about doing it remotely. I do have admin
> rights.
>
>
>
>
| 
XML site map