|
Posted by Malke on October 1, 2006, 8:54 am
If you were Registered and logged in, you could reply and use other advanced thread options
> After updating all four (4) applications, I am unable to perform scan with
> McAfee in either normal or safe mode. When pressing #3 and error message
> appears: "update.ini not opened for read, error code [0]".
>
> I don't experience this with the other three (3) scanning engines. The
> only time I can scan with McAfee is right after update is completed when
> the
> small window pops up indicating "Do you want to run the McAfee CLS now?"
> which is in normal mode.
>
> I downloaded, uninstalled and re-downloaded this wonderful utility several
> times always ensuring that ZoneAlarm FireWall (free version) does not
> block
> WGET.EXE. I even disabled the FireWall completely and started downloading
> the utilities from 1 to 4, from 4 to 1, then 2,3,1,4, then 4,1,2,3 etc.
> but the error sign just appears again and again.
> Would very much appreciate any assistance for get McAfee CLS running
> properly.
I'm sure that David Lipman will be along to set you right. I assume that you
are talking about David's Multi_AV, btw. However, since Multi_AV is a
first-line antivirus tool used to clean up a system before installing a
full-featured antivirus, I wouldn't worry about it if one of the components
won't scan. Just scan with the other three to clean the system up enough to
install your full-time av. Then update the full-time av and do a thorough
scan in Safe Mode. Combine with other malware removal steps to finish
cleaning the box. Refer to these virus/malware-removal steps for more
procedures:
http://www.elephantboycomputers.com/page2.html#Removing_Malware
Malke
--
MS-MVP Windows Shell/User
Elephant Boy Computers
www.elephantboycomputers.com
"Don't Panic"
| 
XML site map