|
Posted by bminson on October 23, 2007, 5:20 pm
If you were Registered and logged in, you could reply and use other advanced thread options
bminson had written this in response to
http://secure-gear.com/comp.security.misc/1/-article-.htm :
-------------------------------------
Notifier AFP-400 HELP
-------------------------------------
Am a computer tech for my local school district, and I have been asked to
look at our fire alarm system. We are about 4 hours from the nearest
service center, so they want to charge us a travel fee that makes our
purchase order amount out of wack!
I have a AFP-400 that has two loops. When we have our drills I have about
80% of the lights and buzzers not working. Its not all on one loop. The
panel doesn't show any problems other than two mods. I have two MONITORS
in a control room that have red flashing lights, and I have other boxes
that say CONTROL with green lights.
HELP!!!
Brian
##-----------------------------------------------##
Delivered via
http://www.secure-gear.com
The Internet Knowledge Base for the security industry
no-spam access to your favorite newsgroup -
comp.security.misc - 9147 messages
and counting!
##-----------------------------------------------##
| 
XML site map