|
Posted by T. Sean Weintz on February 11, 2005, 12:34 pm
If you were Registered and logged in, you could reply and use other advanced thread options
tyranidsss@yahoo.com wrote:
> Hello everyone and thanks in advance.
>
> I recently installed a sonicwall tz170 firewall at our main office. I
> have a small branch that only has 3 pcs, so I would like to route
> internet traffic from them to the main office. We have a Frame relay
> setup already between the two locations. I changed the router config
> on the branch end to send internet traffic to my main. It does that,
> but once it hits the sonicwall it gets an Arp timeout error. Im stuck
> at this point. I can access internet from the main office fine and all
> other traffic between the two locations is fine. Any ideas?
>
> Thanks
>
Did you define the lans at the remote office on the sonicwall? what
version (standard or enhanced) of the firmware is on the tz170?
| 
XML site map