|
Posted by Jake on March 19, 2008, 1:07 pm
If you were Registered and logged in, you could reply and use other advanced thread options
Hi,
I've got a netgear FWG114P and I'm trying to configure a machine to do
outbound HTTP only w/ the following two rules in this order.
I enable an HTTP rule w/ the action "ALLOW always" from 'any' LAN to
'any' WAN. Then in the DEFAULT rule it says 'any' service 'BLOCK always'
from 'any' LAN to 'any' WAN.
Both rules are enabled.
Yet, when I try to get out, HTTP is blocked, but if I set the default
to 'ALLOW always', then I can get through.
Shouldn't the config I put in be saying, allow all HTTP and block
everything else in the listed order? Meaning, it matches the first rule
and that's it if I'm doing HTTP?
| 
XML site map