|
Posted by Jeff Lord on May 3, 2005, 10:17 pm
If you were Registered and logged in, you could reply and use other advanced thread options
Prashanth Rao pounded out on the keyboard on or about 30-Apr-05 19:52:
> Has anyone got SecuRemote to work with Netgear MR814V2?
>
> I am able to connect by my company network without the router. With the
> router, the VPN connection is successful, but I am not able to access
> any resources on my company intranet.
> I tried opening Port 500,256-266 without any luck
>
> Thanks
> PRao
>
Hey, Prashanth.
Have you tried this both wireless and wired? There can be an issue with
the SecuRemote client when trying to use wireless with WEP enabled. If
you have only tried wireless, try wired first to be sure you can get
through. Also, try some of the Advanced Settings like Enable IPsec over
TCP and Encapsulating within UDP. Sometimes those, or a combination of
them, will help you out.
I'm also assuming that your Netgear isn't issuing out IP addresses that
are in the same subnet as your company network. This will definitely
cause you not to get anything from the company network. (SecuRemote will
assume that you are trying to get something on your local network and
not send it down the tunnel.)
Good luck and let me know how it goes and if you have any other questions.
Jeff
| 
XML site map