|
Posted by Ben on July 29, 2005, 11:57 am
If you were Registered and logged in, you could reply and use other advanced thread options
Hi,
I'm trying to setup a basic DMZ for 1 PC that we need on the network, but
not on 'our' network, so to speak (it's another companies laptop, and we
don't know if it has viruses/spyware etc).
We run an internal ip of 192.168.0.0/24, and we have an ADSL router modem,
with 1 ethernet port on the back, (ip address 192.168.0.1), this is
connected to our switch, and everyone in the office uses it as their default
gateway to connect out through. Now I need to allow a PC, that we need to
keep off our network, access to the internet.
The IP address of this PC is 10.0.0.10/8, I've connected it to the untrust
port on a netscreen 5xp, and configured that port with the ip of 10.0.0.1.
Then I've connected the netscreen trust port to the office switch, and added
an ip address of 192.168.0.2. Now I need to be able to get the quarantined
laptop to connect out through the netscreen, through the ADSL modem.
You can configure routing through the netscreen, but I'm unsure of the exact
configuration, should the ports use NAT or routing? How do I configure the
routing table?
Any help much appreciated
Ben
|
| Similar Threads | Posted | | Netscreen 25 DMZ Routing | August 25, 2007, 1:38 pm |
| netscreen 25 routing question | May 11, 2005, 6:00 pm |
| To Alan Strassberg - Routing On Netscreen 5XP | August 3, 2005, 10:51 am |
| routing | March 1, 2005, 7:38 pm |
| VPN and routing between branches | July 21, 2005, 10:59 am |
| Routing question.. | October 25, 2005, 2:00 pm |
| Checkpoint routing | May 17, 2006, 11:28 am |
| Simple (?) routing question | November 23, 2004, 12:36 am |
| TCP Routing/IPTABLES question. | February 23, 2005, 10:00 am |
| routing issue on SunScreen fw | March 24, 2005, 12:47 am |
|
XML site map