|
Posted by dtree on July 21, 2004, 12:49 pm
If you were Registered and logged in, you could reply and use other advanced thread options
Actually I think I just answered my own question.
I've finally found the proper VPN client to atleast connect in admin
mode to the public address and access the web interface remotely.
I still haven't done it with XP but with this client i should be able
to. I may have been hozed by the xp firewall also.
for future reference
http://www.sprint.com/business/products/products/popup/popupVpnIndex.jsp
is a site with lots of VPN client downloads.
http://webramp.computechdata.com/
is a site with the safenet vpn client 8.0 from sonicwall
hope this helps someone else.
d_tree wrote:
> I was wondering if anyone has ever been able to setup the windows XP
> built in ipsec via secpol.msc . I've tried a few other 3rd party
> clients but non of them seem to have all the fields I need to get the
> vpn connected. I recall in the old VPCOM software I needed to have
> everything perfectly matched in the fields of USERNAME,my local IP
> address (virtually), SERVIER ID, among other details.
>
> I found a guide on this process using the sonicwall (similar to the
> webramp700s) but these instructions were based off a slightly newer
> firmware i believe. In any case, I can't seem to get it connected and
> would appreciate any insite on the procedure.
>
> ftp.sonicwall.com/pub/info/vpn/WinXP_to_SNWL_VPN.pdf
>
> Please reply by EMAIL if possible, i do not check this group often.
>
> dtree.dtree
> AT
> gmail.com
>
> thanks
> d
| 
XML site map