|
Posted by le_brito on October 2, 2006, 1:55 pm
If you were Registered and logged in, you could reply and use other advanced thread options
Dear all,
I'm trying to set up a dial up vpn so that some remote users could
reach more than one subnet at the trust side.
On the client side, there's the "Remote party Identify and Addressing"
where I set the other side of the VPN Gateway.
I'm trying to discover how can I configure on the client to add more
than one subnet.....on the trust side.
Any ideas...
regards,
Leandro
| 
XML site map