|
Posted by Somebody. on October 7, 2005, 7:41 am
If you were Registered and logged in, you could reply and use other advanced thread options
> Hello people
>
> I've got a horrible problem and I think it may be hardware related.
>
> I've been given two Netscreen 100 firewalls (the company that gave
> them to me was upgrading and they were going to throw them away).
>
> Spec of the Netscreens are;
>
> HW Version 3110(0)-(11)
> Image: ns100 3.0.3r5
> and
> HW Version: 3110
> Image: ns10ns100 3.0.1r1.0
>
> The first netscreen is fine. did an unset all, then a reset, set my PC
> to 192.168.1.2 and pointed my browser at 192.168.1.1, logged in as
> netscreen/netscreen, and I got a "Welcome to Netscreen-100" config
> window
>
> For the second netscreen...
>
> I attached a console cable to the console port (obviously!) and
> luckily the netscreen root password was left at default. I did an
> unset all, reset, without resaving the settings, and everything went
> back to the factory default.
>
> I then set my PC to 192.168.1.2 and tried connecting via IE to
> 192.168.1.1. This refused to connect.
>
> The firmware image on this second netscreen is older than the first.
> Do I need some other way to connect to the netscreen to configure it?
>
> Any help appreciated
>
> Ken Z
Log in to the console using the serial number as the username and the
password. That does an actual factory reset which is different than an
unset all.
Then do a tftp update from the command line using the same firmware as the
other box. (You can get that from the folks that gave you them, right?)
Of course 4.0 firmware would be nicer, as mentioned by the other fellow.
-Russ.
| 
XML site map