|
Posted by on February 27, 2007, 5:02 pm
If you were Registered and logged in, you could reply and use other advanced thread options > On Feb 26, 6:48 pm, neilp...@hotmail.com wrote:
>
> > Hello,
>
> > At present I have a Single IP address setup with a Netgear DG814, the
> > WAN address is static and provided by the ISP and the LAN IP address
> > is configured ok (192.168.0.0/24), everything works fine. However I
> > have decided to purchase a Netgear FVS114 to allow for VPN connections
> > and provide better security. Given the fact that I only have one
> > public IP address which is being used on the DG814 modem, what IP
> > address do I assign to the WAN address of the new FVS114 VPN Router?
> > Can I use a private IP address on the LAN side of the DSL modem and on
> > the WAN & LAN addresses of the VPN Router or does the WAN address of
> > the VPN Router have to be a public IP address as well?
>
> > Thanks
>
> Since the Netgear DG814 is your gateway to the outside world you need
> to use the same WAN IP to reach your VPN router. Then you need to do
> port forwarding to the LAN IP of the FVS114.
Thanks for your reply, after much reading I have managed to get it
working by using the Static IP on the WAN of the DG814 and then have
the LAN IP of the DG814 and WAN IP of the FVS114 on the same network
then have the LAN IP of the FVS114 on the same network as the internal
network. Creating a DMZ and have port forwarding to the LAN IP of the
FVS114 as you suggest - all works fine. Thanks
| 
XML site map