|
Posted by The Tanster on February 29, 2008, 8:13 pm
If you were Registered and logged in, you could reply and use other advanced thread options
I have a situation where a Netgear FVG318 seems to be routing *ALL*
traffic through the VPN whenever the VPN policy is active, even when
there there is no VPN active! When a VPN is active, every device on the
LAN can ping the remote user through the VPN and vice versa but not each
other. All devices on the LAN cannot even get out to the WAN since all
traffic seems to be going through the VPN. The VPN policy was crafted
through the VPN Wizard on the FVG318 for a travelling user where the
remote IP is not known at configuration time. In this case, according to
KB articles on Netgear's site, the remote IP should be set to 0.0.0.0
which ends up being set to "Any" when the VPN policy comes out the other
end of the VPN Wizard. It seems to be wanting static routes that state
that only traffic intended for the travelling user should go through the
VPN tunnel and all else should be routed out through the FVG318 where it
either goes out through the WAN port or left inside the LAN but
shouldn't the VPN Wizard already have taken care of this? Does anybody
have any insight into this? This is with firmware rev 1.33
| 
XML site map