|
Posted by Memnoch on December 29, 2005, 8:58 am
If you were Registered and logged in, you could reply and use other advanced thread options
>Hi Firewall admins,
>
>Am struck with a strange issue with my Checkpoint firewall.
>My firewall is running on a Solaris 9 box (280R) with Checkpoint NG
>with AI (R54). Last week server went down and found to be RAM issue.
>After the inter-change of RAM banks server came up and everything seems
>to be fine till i pushed the policy.
>
>Policy doesnt gets compiled and it gives me a error as
>
>"Installation Failed"
>
>Reason : SIC General failure ( SIC Error NO. 148)
>
>Would appreciate any help on this.
>
>Solomon
From the KB:
Solution
This error means a timeout has occurred during the SIC process.
Procedure:
1) Check connectivity between Management Server and enforcement point
2) Run "fw unloadlocal" on the enforcement point to unload policy
3) Test SIC again
Note: If it works then the problem lies with the Policy and not with SIC.
| 
XML site map