|
Posted by LW on October 6, 2006, 9:39 pm
If you were Registered and logged in, you could reply and use other advanced thread options
I used to stuck at this problem in the past and like to hear if any one
know how to resolve it.
Network Administrator
http://www.linkwaves.com
www.ipnetworks.it wrote:
> Is there anyone (maybe with a cisco smartnet that can send email to
> tac@cisco.com) that can answer to my question:
>
> - topology -
>
> 2 ASA version 7.2(1) connected to internet each with 5 Mbps of internet
> bandwidth and established with one another a L2L IPSec VPN tunnel.
>
>
>
> - request -
>
>
> need to configure qos only across this Lan to Lan IPSec tunnel with the
> following mode: with 5 Mbps total bandwidth need to rate 3,5 Mbps for L2L
> VPN with a rate limit policy.
>
> In particular need to configure for this IPSec tunnel a policy that set 2
> Mbps for the http traffic, 1 Mpbs for the https and 500 kbps for all the
> other traffic inside the L2L IPSec.
>
>
>
> Any configuration example on this would be greatly appreciate.
| 
XML site map