|
Posted by on December 7, 2007, 8:09 am
If you were Registered and logged in, you could reply and use other advanced thread options
This is my first Cisco product that I've tried using the new (ASDM)
GUI interface to set up. I have to say that I'm surprised at how
difficult the GUI interface is for configuration compared to other
products. But maybe I just need to learn my way around it more.
Can someone help me with the VPN and GUI?
I configured VPN via the GUI, but I do not see any way to check the
status of the VPN or even a place to "connect" and/or
"disconnect" (bring up/down). I'm trying build a tunnel to a LinkSys
WRV54G. Does the GUI provide this level of support or do I need to go
back to the command line? How do I know if the Cisco is trying to
connect?
Are there any good books or docs on how to sue the new GUI (ASDM)?
Thanks:)
| 
XML site map