|
Posted by Rich on February 3, 2008, 2:35 am
If you were Registered and logged in, you could reply and use other advanced thread options
I have just reloaded my sidewinder 5.2 and I am at the point where I need
to start entering Network Objects so that I can start creating the ACLs.
But when I try to add any external or DMZ IP address the Network objects
table, I get an error message "This ip address is not an external
address." For ex burbample, I have three zones 147.14.48.1 (internal burb),
147.14.46.1 (DMZ), and 147.14.47.254 (External burb). I can only add IP
addresses which match the internal burb.
Anyone know why, or experience this. This is a clean reload.
Rich
| 
XML site map