|
Posted by Jean-Sebastien on December 22, 2004, 6:15 am
If you were Registered and logged in, you could reply and use other advanced thread options
Hy,
I am configuring a Lucent 350 brick in routing mode. The brick is
connected to the LSMS via the eth0 interface.
I thus have two rulesets zones applied to eth0:
1. The "admin" ruleset which is the system default ruleset that opens
administration flows between the firewall and the LSMS.
2. I have added a second ruleset on eth0 on top of the 1st one.
The problem is that it seems that the firewall does not look at
ruleset #2 : all packets are dropped by the last rule of the "admin"
ruleset, which is "any any drop".
I have tried to exchange the ruleset order whithout any success
without any success.
The only workaround I found is to add my rules directly in the admin
zone ruleset, which is not satisfactory.
Thanks in advance for any useful comment.
Js
|
| Similar Threads | Posted | | I BUY used, new and refurbed Sun, Cisco, Lucent, Nortel, Alcatel, 3com, IBM, HP, Compaq, Dell, Madge, Cabletron, Juniper Networks, Bintec, Siemens, Foundry, Networks, Extreme Networks, Fore/Marconi, Tellabs Lucent/Avaya/Ascend, Xylogics, Brocade, Int | May 6, 2008, 2:23 am |
| I am looking to buy Cisco, Lucent, Nortel, Alcatel, Juniper Networks, Bintec, Siemens, Foundry, Networks, Extreme Networks, Fore/Marconi, Tellabs Lucent/Avaya/Ascend, Xylogics, Brocade, Intel, Motorola, Nokia VPN/Firewall, Netscreen, Microsoft Adobe, | February 24, 2008, 8:23 am |
| configuring IP range for zones | September 19, 2007, 3:26 pm |
| Using Port Based VLANs to isolate security zones | February 29, 2008, 3:55 pm |
| managing multiple firewalls | May 18, 2005, 9:45 am |
| managing multiple firewalls | May 18, 2005, 9:45 am |
| Lucent Brick > OpenVPN ? | January 20, 2006, 4:25 am |
| Attn: Lucent Brick Users | November 5, 2004, 6:02 pm |
| simple iptables ruleset? | March 30, 2007, 8:08 am |
| Testing the firewall ruleset in my router | June 13, 2006, 7:59 am |
|
XML site map