|
Posted by Nino_1 on February 8, 2008, 5:17 pm
If you were Registered and logged in, you could reply and use other advanced thread options
Just recently dusted off this old firewall appliance and was tasked
with getting it going. When attempting to access the firebox in
"Enahnced System Mode" via x-over cable on two interfaces and
connecting via TCP/IP to the trusted ethernet port the system does not
go into Enhanced System Mode nor does the SysA light flash.
Does anyone know of a method of accessing this firewall to bring it
back to operational.
Thanks in advnace.
Nino
I used the method descibed in this post:
http://groups.google.com/group/comp.security.firewalls/browse_thread/thread/3ce1ee0d386cd8a7/2ef94901ee4ee2ae?hl=en&lnk=gst&q=Enhanced+System+Mode+Firebox+II#2ef94901ee4ee2ae
| 
XML site map