|
Posted by Fidelio on December 31, 2004, 10:24 am
If you were Registered and logged in, you could reply and use other advanced thread options
I have a dmz called dmzras with network address 192.168.102.0 and a inside
network which belongs to 10.0.0.0 255.0.0.0. I want to give access from any
dmzras ip to any inside ip but having NAT to the CISCO PIX inside address in
order to avoid routing the network 192.168.102.0.
So I place this:
access-list inside_access_in permit ip 192.168.102.0 255.255.255.0 any
But I have no idea on how to configure the NAT rule to give all incoming
traffic from dmzras to inside the ip address of the firewall at inside
interface.
Thank you in advance.
Fidelio
| 
XML site map