|
Posted by on April 24, 2008, 4:36 pm
If you were Registered and logged in, you could reply and use other advanced thread options
> *182 is for custom zones
> just use *56 area and the zone types I gave or any of the standard ones on
> page 12
>
> --
> **Crash Gordon**
>
>
>
> > wrote:
> >> I hardly ever use customizable zone types.
> >> Is there a reason you don't want to use normal zone types?
>
> >> 01 Entry/Exit #1 - delayed doors
> >> 03 Perimeter - instant doors/windows
> >> 04 Interior Follower - interior device (pir) that follows entry delay if
> >> delay zones are faulted first... but instant in other cases
>
> >> --
> >> **Crash Gordon**
>
>
>
> >> > Has anyone programmed an Ademco Vista 20P? Whats a typical entry for
> >> > *182:
>
> >> > 1) door switches
> >> > 2) IR motion
>
> >> > thanks
>
> > Im after just a vanilla setup, the manual implies that *182 is
> > required so thats what I was trying to get working.
> > Sounds like that is not right so Im open. Is *56 the right field?
after *97 and *56, the Vista finally came up and showed some life.
testing is next
Thanks!!!
| 
XML site map