|
Posted by Mark Leuck on October 21, 2006, 5:20 pm
If you were Registered and logged in, you could reply and use other advanced thread options
> Yeah its like some HUGE secret that the alarm co's want to bone you up
> the hoop for a piddly service call. This should work for a Simon 2 but
> may work for a v1 and v3
You'll then need another piddy service call to reprogram your now defaulted
panel
>
> Reset Memory to the Factory Defaults
> If it becomes necessary to set all programming back
> to the factory defaults, do the following:
> 1. Open the Control Panel cover.
> 2. Unplug the transformer and the battery.
> 3. Simultaneously press Cancel, Clock Set, and Minutes.
> 4. Restore power to the panel with either the battery
> or the transformer while pressing these three buttons.
> 5. Plug in the transformer or connect the battery.
> NOTE: If Phone Lock is on, options 04, 05, 06, 08, 09,
> 12, and 13 will not reset to their defaults.
>
>
> Chub:
> > can you panel hackers reset the Simon installer code?
> > I have a commercial customer that purchased a house with one of these.
> I
> > told him to contact original company to get code but if that fails I
> would
> > like to know what my options are.
> > TIA
| 
XML site map