|
Posted by George Siegle on August 10, 2007, 10:42 am
If you were Registered and logged in, you could reply and use other advanced thread options
http://www.netwell.com.tr/pdf/SecurityCustomElectronics2006.pdf
Page 28 shows both key pads with Zone Ezpanders.
> Found it! Honewell makes a 6151 (Fixed English keypad with a single
> zone) and 6164 (Alpha keypad with 4 zone expander) Life can
> continue...
>
>
> wrote:
>
>>The only way I can think of to do it (without running wire or adding
>>wireless) is to add 4219 (8 zone expansion module) to the keypad bus and
>>then add the front door (and what ever else you want) to the 4219 zones.
>>You
>>could stuff the 4219 in the wall behind the keypad once you get the wire
>>from the door to the keypad.
>>
>>> Ive been out of the business for a few years, so Ive forgotten how to do
>>> this:
>>>
>>> Wire the E/E door, using the 22/4 keypad wire.
>>>
>>> Basically, the front door didnt get wired at the rough-in stage. Its
>>> impossible to do now, and I dont want wireless. The keypad is right
>>> next
>>to
>>> the door in question. I seem to recall there is a way to wire them both
>>> together on the one 4 conductor wire.
>>>
>>> Any ideas would be appreciated.
>>>
>>> Thanks.
>>>
>>>
>>
>
| 
XML site map