|
Posted by rfalcone on September 18, 2006, 12:02 pm
If you were Registered and logged in, you could reply and use other advanced thread options
I do have a keypad connected and the programming manual.
I go to *56 to enroll the devices. I have programmed these devices
before when my system was previously configured. My old system had
hardwired devices , with an expansion box and the wireless receiver
with wireless devices. I got rid of the expansion box and just want all
wireless.
I thought I would start enrolling upto 16 devices at zone 10, but I
can't seem to select zones 10 - 26.
The system only seems to see zones 01-09, 92, 95, 96 and 99.
I assume that I have the 5882 connected correctly, in parallel with the
keypad and set to address 0.
I don't see anything else to do.
Frank Olson wrote:
> rfalcone wrote:
> > I did major renovations to my house which involved removing my entire
> > wired alarm system. And I want to re-install my previously hard wired
> > Vista 20SE with all wireless sensors and keypads. I reset the system
> > back to the default and removed zones 01-08. I got a 5882 wireless
> > receiver and connected it to the keypad connections on the control
> > panel and set it to address '0'. I thought I would see the 16 new zones
> > starting from zone 09 or 10, but I don't. I do have a zone 09 with zone
> > type 05 (expansion module supervision). The next zones I see are 92 -
> > 99.
> >
> > Is there something more to connecting up the 5882 on the 20Se ?
> >
> > What should be the starting wireless zone offset ?
> >
> > Any other information is greatly appreciated.
> >
> > Thanks.
> >
>
>
> You have to enroll each wireless transmitter, then assign it a zone type
> and other attributes. You'll need a 6139 keypad and the programming
> manual to do this. Good luck!
| 
XML site map