|
Posted by Paul Ekins on October 20, 2006, 5:13 pm
If you were Registered and logged in, you could reply and use other advanced thread options
Hi Rolf,
If you have kept the sensors in the same place the panel will have the same
programming as when you powered it down and will work the same. Beware,
there was two different versions of that panel and they program differently.
If you need help try a local engineer at the following link. You will find
your area in the left plane toward the bottom.
http://groups.msn.com/UKSecurityPanels/_whatsnew.msnw
A fine is a tax for doing wrong. A tax is a fine for doing well.
Paul Ekins
Linc Secure
> Hi all,
>
> Looking for the installation/engineers manual for this alarm, I have
> the user guide but the whoel panles been disconnected whilst the
> hallway was replastered so I'll need to reprogram all the areas etc.
>
> Thanks in advance for any help.
>
> Rolf
>
| 
XML site map