|
Posted by nick markowitz on April 22, 2008, 7:13 pm
If you were Registered and logged in, you could reply and use other advanced thread options
I have had problems with my ir reader to they said replace unit I think its
a go no go tester depends on when smoke was bought. have found no good
answer to problem
> Does anyone else have any problems with the System Sensor 'Sens-Rdr' IR
> sensitivity tester?
>
> I seem to have a problem getting readings quite often. I just finished a
> test with two loops of smokes on an FA1600. Zone 1 smokes gave readings
> with no problems but the zone 2 smokes wouldn't. When I tested them with
> 'smoke check' they performed perfectly, but I couldn't get a single
> sensitivity reading.
>
> I called system sensor and their advice was to try it with the lights
> out - no difference, except I banged my shin (they are in a basement).
| 
XML site map