|
Posted by Jim on August 6, 2006, 2:26 pm
If you were Registered and logged in, you could reply and use other advanced thread options
Key Bored wrote:
> Hi All,
>
> I'm looking for a wireless device that will automatically turn OFF a table
> lamp (or other item) plugged into a standard 120V wall outlet when a remote
> sensor is activated. For example, a person walks into a room and is
> detected by a wireless door switch, a motion detector, or other sensor.
> This sends a signal to a receiver module that causes the lamp to turn off.
>
> The ideal setup for my purpose would be to have a portable motion detector
> that would deactivate or switch off a module plugged into the wall outlet.
> This would allow more flexibility in locating the motion detector and the
> receiving module. I checked Radio Shack website but couldn't find anything.
> I'd like to keep it simple and not do any hard wiring. Any suggestions?
>
> Thanx,
> Key Bored
Do a search on X10 and/or power line carrier or PLC Check out
Smarthome.com
| 
XML site map