|
Posted by Crash Gordon on August 18, 2005, 3:41 pm
If you were Registered and logged in, you could reply and use other advanced thread options
http://support.radioshack.com/support_security/doc17/17355.htm
And again...not sure if this is for the keypad you have either..
hth
>I don't see the sheet Crash? The only programming it needs (I'm guessing)
> is setting up codes to turn the alarm on and off.
>
> Thanks,
>
> Jim
>
>> here's a sheet for the 49-452 keypad... I can't remember if that was the
>> right one for thqt system or not...been a looonnnng time since I worked
> for
>> Radio Shaft.
>>
>>
>> > My wife's church just replaced the batteries in their Radio Shack Safe
>> > House
>> > 49-450B security system but they don't have the manual to reprogram it.
>> > The
>> > RS Web site has all the technical details (specifications,
>> > installation,
>> > panel pictures, troubleshooting etc.) but no owner's manual for the
>> > programming from the keypad.
>> >
>> > There are a couple of these items (or similar) on eBay but don't want
>> > to
>> > buy
>> > one, just need to know how to program it, it was working fine before
> their
>> > power failure.
>> >
>> > I've searched the Web and newsgroups but haven't found any references
> that
>> > would point me to a good source.
>> >
>> > This particular newsgroup appears to support the professional community
>> > more
>> > than the do-it-yourselfer so do apologize for the intrusion.
>> >
>> > Any info is appreciated, thanks.
>> >
>> > Jim
>> >
>> >
>> >
>>
>>
>
>
| 
XML site map