|
Posted by Frank Olson on October 20, 2005, 7:38 pm
If you were Registered and logged in, you could reply and use other advanced thread options
>I have a Napco P3200, capable of 32 max zones wired/harwired. If I
> program a keypad 4-zone expander, and use one of the zones on that
> keypad, am I now screwed out of the other 3 zones if they go unused? In
> other words, do I now have 28 zones available at the panel and 4
> available at the keypad, making 32 in total? If the keypad occupies
> zones 29-32, I MUST use the zones AT THE KEYPAD or not at all?
Yep. It doesn't look like Napco makes a single zone expander
(unfortunately). You have a total of 32 hard wired zones available through
either EZM8 modules (8 zone expanders), the 8 zones already on the panel,
and the keypad zone expanders. You don't have an option of using one zone
from one four zone keypad expander and another from a second four zone (or
EZM8). They system will automatically assign the zone numbers on the
expanders when you enter the device addresses.
| 
XML site map