|
Posted by Bob La Londe on May 26, 2006, 1:26 pm
If you were Registered and logged in, you could reply and use other advanced thread options
My old laptop went to the shop for repairs, so I dug out my new one and
loaded all the software up and plugged in the Napco provided USB to RS-232
adaptor. It worked with the driver for the USB to serial adaptor I already
had loaded for my HAI software. All I had to do was go into the device
manager and set the serial port. I don't know if the Napco software will
work with higher than the standard ports 1-4 so I just set the adaptor to
port one (3&4 were already in use).
Loaded the Napco software, set it for port 1, and plugged into the P9600 I
have on my test bench. It worked great and if anything its faster.
Now to go out and use it. Lots of stuff to install and program.
--
Bob La Londe
Fishing Arizona & The Colorado River
Fishing Forums & Contests
http://www.YumaBassMan.com
*** Posted via a free Usenet account from http://www.teranews.com ***
| 
XML site map