|
Posted by Bob La Londe on July 9, 2006, 10:50 pm
If you were Registered and logged in, you could reply and use other advanced thread options
Also, there are two jumpers on the board for seven eight which set them as
either two wire fire or burg zones.
They do not wire the same for fire as burg. There is a wiring diagram on
the door of the panel.
Also, there should be address programming in the programming manual.
>
> Knight Houston wrote:
>> Bob La Londe wrote:
>> > >I am having trouble geting to the easy menu mode. On Page 47 of the
>> > > install manual it shows the easy menu mode. I am trying to access the
>> > > area of "# of zns in Area!1*"
>> >
>> > A lot of stuff is only accessible the first time you enter the easy
>> > menu.
>> > After that you have to go to address programming or use the PCD
>> > software.
>> >
>> >
>> > --
>> > Bob La Londe
>> > Fishing Arizona & The Colorado River
>> > Fishing Forums & Contests
>> > http://www.YumaBassMan.com
>> >
>> >
>> >
>> > --
>> > Posted via a free Usenet account from http://www.teranews.com
>>
>> is there a address guide ?
>
> I am also have a fault in zone 8 with a resistor in line. when I hook
> up common for 7 and 8 I get a fault in both zones .... not
> understanding... is there a factory reset button?
>
--
Posted via a free Usenet account from http://www.teranews.com
| 
XML site map