|
Posted by Danny on January 9, 2006, 3:55 pm
If you were Registered and logged in, you could reply and use other advanced thread options
Hi Folks
Just purchased an older building and it was equiped with an old Paradox
Esprit 738+ version 3.10.3 - I don't have a manual for it - but got a
hold of a manual for the 728 - close but wiring digram is different.
Still tracing wires but so far I have determined thefollowing:
> This unit has a battery,
> 5 motion sensors,
> 2 door senors, (one is programmed to chime bell)
> 636 keypad (not sure model) and a bell.
Not sure if it has an auto dialer or not? I would like to reprogram the
system and use it again. All senors are appear functional (blink red /
green) and cause the corresponding keypad button to light up.
Previous owners do not have any codes for it...and not local rep or
distributor for paradox. Being an IT programmer - I was hoping to do it
myself with a bit of help and a manual.
Any help would be appreciated.
Danny
| 
XML site map