|
Posted by on March 16, 2006, 10:59 pm
If you were Registered and logged in, you could reply and use other advanced thread options
modules are set not to report tamper I will have to double check the jumper.
cel
> What modules do you have connected?
>
>
>
> > How do I get rid of "general system tamper" code on a DSC 864? I used
the
> > DSC windows software to read the status I this code is set along with
TLM
> > and Low Battery. The status on the keypad only shows general system
tamper
> > as the only fault. I tried clearing out the latch error with the
software
> > but they still show up on the status rpt on the PC. I am not using a
phone
> > line yet and have disable TLM in the configuration. I don't have a bell
> > connected, so I added a 1K resistor across the bell contacts. These
> > changes
> > got rid of my TLM and Bell trouble codes, but not the general system
> > tamper?
> >
> > cel
> >
> >
>
>
| 
XML site map