DSC PC5108

Secure Home | Search | About

Lost Password?

CCTV, Alarms and other Physical Security

get this group's latest topics as an RSS feed

add this group's latest topics to your My MSN content

add this group's latest topics to your My Yahoo content

add this group's latest topics to your Google content

Subject

Author

Date

DSC PC5108

Frank Olson

03-23-2008

Re: DSC PC5108

Crash Gordon

03-23-2008

Re: DSC PC5108

Frank Olson

03-23-2008

Posted by Frank Olson on March 23, 2008, 8:18 pm

If you were Registered and logged in, you could reply and use other advanced thread options

Where the heck does DSC hide the version number of this module. It
states in the 1864 manual that you can't mix version 1.0 and version 2.0
on the same installation. This is an upgrade from an 832 panel
(customer needs more user codes).

Posted by Crash Gordon on March 23, 2008, 9:41 pm

If you were Registered and logged in, you could reply and use other advanced thread options

It's screened right on the board under the part number - with the terminals
on the bottom facing you they're on the top right. At least it is on the
several pulls I have.

--
**Crash Gordon**

| Where the heck does DSC hide the version number of this module. It
| states in the 1864 manual that you can't mix version 1.0 and version 2.0
| on the same installation. This is an upgrade from an 832 panel
| (customer needs more user codes).

Posted by Frank Olson on March 23, 2008, 11:58 pm

If you were Registered and logged in, you could reply and use other advanced thread options

Crash Gordon wrote:

> It's screened right on the board under the part number - with the terminals

> on the bottom facing you they're on the top right. At least it is on the

> several pulls I have.

Thanks. I'm not at the office (so I can't pull one from stock). I'll
relay that information to my tech. I was reading over the install
manual and found that little notation (that you can't mix versions).
Much obliged, Crash.

The site map in XML format XML site map