|
Posted by Paul Ekins on September 15, 2005, 4:24 pm
If you were Registered and logged in, you could reply and use other advanced thread options
> |I downloaded the Vista 10SE "Installation Manual" from...
> | http://www.ademcoint.com/english/library/ademco.htm
> |
> | ...but the list of programming codes in this manual seems to be
> incomplete.
> | Also scattered, no one listing of all codes.
> |
> | I've ordered the 6139 alphanumeric keypad. (Currently have 6128 RF)
> |
> | I'm an old time alarm repairman who last worked on alarms in the 80's
and
> | I'm *finally* getting around to installing my own alarm...
> |
> | But I see everything has changed quite a bit!
> |
> | The last system I worked on was an early 80's Radionics. With the add on
> | "programmer", I could set things like zones: [perimeter - interior -
> | instant - delayed - fire - etc.], local or monitored, siren run time
> before
> | shutting off, etc.
> |
> | So I would like to change these settings on the Vista 10SE as well. I
may
> | have just a local alarm or may get monitoring depending on my finances.
> |
> | I found the following programming manuals on the above web site. This is
> | the type of thing I am looking for, except for the 10SE. Are any of
these
> | compatible with the 10SE so far as having the same codes?
> |
> | Vista-100
> | Vista-128B
> | Vista-128FB
> | Vista-40
> | Vista-50P/Vista-50PUL
> |
> |
> |
>
>
| 
XML site map