|
Posted by Russell Brill on August 7, 2005, 3:37 am
If you were Registered and logged in, you could reply and use other advanced thread options
http://www.optexamerica.com/products/prodpage.cfm?product=sx360z
> It has been some time since I installed a ceiling motion detector.
> This is a commercial bank (Lobby), the ceiling being about 16 feet
> high, and the floor area being about 40' x 40'. I do have the choice
> of using several wall/corner units, that would mount about 10' from
> floor. What would you use . . . the ceiling unit @16' or the wall
> units @10'. Also, for each type, what type (such as dual tech. or pir
> only, and what make would you use, (such as Intellisense or Optex)
> based on your past experience. Many thanks for your help. Robert
>
| 
XML site map