|
Posted by Roland Moore on January 31, 2008, 1:30 am
If you were Registered and logged in, you could reply and use other advanced thread options
the MA 3000 (for latest updates & for better security) from him or some
local dealer. Let him walk you through your programming problems.
> I'm using the master security code that is printed on a label in the
panel.
>
> dyz
>
> >
> >> Hello all,
> >>
> >> We just bought a home with this system already installed. I decided to
> >> make a few changes such as
> >> correcting the time and changing the user code. However, for some
reason
> >> the keypad display would
> >> go back to SYSTEM READY as soon as I press the [on/off] buton when
ACTIVE
> >> PROGRAM
> >> is displayed. I've read the manual many times and could not find any
> >> info to explain this. Anyone know
> >> what's the problem is?
> >>
> >> Thanks!
> >>
> >> DYZ
> > I'm not familiar with that panel, but you probably need the installer
> > code, not a user code to enter programming. I don't know what the
default
> > code is but If I recall correctly older Napco panels had the default
code
> > on a label on the circuit board somewhere
> >
> > Doug
> >
>
>
| 
XML site map