|
Posted by Jim Rojas on July 18, 2005, 8:53 pm
If you were Registered and logged in, you could reply and use other advanced thread options
Jim Rojas
> Jim Rojas wrote:
>> Brinks uses speakers, not self contained sirens. You can either install a
>> siren driver, or replace it. Your smoke detector should be compatible if
>> it is a 4 wire smoke.
>>
>> Jim Rojas
>>
>>
>>>I am an home owner with an existing brinks system in my home that
>>>previous owner put in 5 years ago.
>>>
>>>I am going to remove the brinks system but use the existing wiring and
>>>the door/window sensors. I will replace the control panel and keypad.
>>>Is it possible to reuse the siren and smoke detector from the brinks
>>>system?
>>>
>>>I have looked at a few options and I am thinking of getting the CADDX
>>>NX-8 with the NX-148E control panel.
>>>
>>>Any opinions about this unit? I will be doing the replacement myself
>>>and possibly with the support from the vendor I am getting it from, and
>>>this NG.
>>>
>>>Initially I will be using it as a local system but definitely would
>>>consider monitoring service in the future.
>>>
>>
>>
>>
> caddx uses spks also. or can be selected for voltage out in program.
| 
XML site map